Azbil dcp551 mark II - Mode transitions

5-26
■ Mode transitions
● Program operation
Mode transitions are indicated by the solid line arrows and end operation is
indicated by the dashed lines in the figure below.
NOTE
• AUTO ⇔ MANUAL mode changes can be made in the boxes of each mode.
• READY and END at the end of operation can be selected using setup data
C31.
● Constant value control
Mode transitions are indicated by the solid line arrows.
NOTE
AUTO ⇔ MANUAL mode changes can be made in the boxes of each mode.
● Switching between program operation and constant value control
Constant value control data “ConSt ” control mode item in the READY mode is
used to switch between these two modes.
0: Program operation
1: Constant value control
NOTE
Constant value control is available only when setup data setting C21 is set to
more than 0. When C21 is set to 0, ConSt is also set to 0.
END AUTO
END MANUAL
READY AUTO
READY MANUAL
RUN AUTO
RUN MANUAL
HOLD AUTO
HOLD MANUAL
RESET
RUN
RESET
HOLD
RUN
READY FAST AUTO
READY FAST MANUAL
FAST AUTO
FAST MANUAL
ADV
RESET
ADV ADV
FAST
RESET
FAST
FAST
HOLD
RUN
RESET
RUN
ADV
ADV
Chapter 5. FUNCTIONS
READY AUTO
READY MANUAL
RUN AUTO
RUN MANUAL
RUN
RESET