Azbil dcp551 mark II - Chapter 5. FUNCTIONS; 5-1 Data

Chapter 5. FUNCTIONS
5 - 1 Data
5-1
■ Data types
The data types are listed below.
For further information on data types, see “Chapter 7. PARAMETER SETUP”
and “Chapter 8. PROGRAM SETUP”.
Data Parameter Variable parameter
Constant value control data
Setup data
PID parameter
Event configuration data
Program Pattern
PV shift
G.SOAK
PID group and output limiter
group number
Event
Repeat
Tag
Pattern link
Cycle
PV start
Data changeable in RUN mode
Event type data
PID group and output limiter group control parameters
Basic data only changeable in the READY mode
Constant value control SP, PID and other data
SP and time, SP and θ or SP and
∆ SP data
Data for event 1 to 16
Data for PID group number used for control
and output limiter group number
Data indicating whether G.SOAK is provided or not
PV shift data
Data indicating whether repeat is used or not
Data indicating whether PV start is used or not
Cycle count data
Pattern link destination program number data
Tag (8 characters) data