Azbil dcp551 mark II - 9-2 Save Procedures

9 - 2 Save Procedures
9-2
Insert a memory card when the DCP551 is in the READY mode and the normal display mode. Press the SAVE
key to start a save operation. “CArd ” is displayed in display panel 1 and “SAVE ” is displayed in display panel 2.
An error code appears if something should go wrong during the save operation.
■ Save menu
When the SAVE key is pressed in the normal display mode, the save menu panel
is displayed. Use the and keys to select the desired menu.
Press the ENTER key to display the desired menu in the message display panel.
The DISP key returns you to the normal display mode.
Normal display mode
Saves individual programs
SAVE key
ENTER key
Save DCP--->Card
Program?
■ Procedures for saving single programs (page 9-3)
Saves all programs
Save DCP--->Card
All Programs?
ENTER key
■ Procedures for saving all programs (page 9-4)
Saves setup data
Save DCP--->Card
SETUP Data?
ENTER key
■ Procedures for saving setup data (page 9-4)
Saves variable parameters
Save DCP--->Card
PARA Data?
ENTER key
■ Procedures for saving variable parameters (page 9-4)
Saves PID parameters
Save DCP--->Card
PID Data?
ENTER key
■ Procedures for saving PID parameters (page 9-5)
(including fixed command control data)
Saves event configuration data
Save DCP--->Card
EVENT Data?
ENTER key
■ Procedures for saving event configuration data (page 9-5)
Saves all parameters
Save DCP--->Card
All Parameters?
ENTER key
■ Procedures for saving all parameters (page 9-5)
Initializes card
Save DCP--->Card
Format?
ENTER key
■ Procedures for formatting cards (page 9-3)
DISP key
key
key
key
key
key
key
key
key
key
key
key
key
key
key
key
key
Chapter 9. MEMORY CARD OPERATIONS