6 - 2 Basic Display Selection
6-2
The console basic display status is comprised of the program number display, segment number display, display
panel 1, display panel 2, basic display LEDs and the message panel.
Use the DISP key or MESSAGE key to cycle through the different displays. The mode display LEDs perform
the same functions both in the basic display status and during parameter settings and do not change by pressing the
DISP or MESSAGE key.
The displays and their functions are shown in the figure below.
CYC
OUT
DEV
PV
SP
TM
SYN
PROG SEG
PROFILE
Program and segment number display
Program
number
Segment
number
PV
SP
Pattern trend
Displays the program and segment number of
the selected program in the READY program run mode.
Displays the program and segment number of the
program and segment number of the currently running
program in modes other than READY mode.
Both displays are off in the fixed command control mode.
Profile display
Indicates when a program has been set in
program run mode. The display is off when no
setting has been made.
When a setting has been made, but there is
no next segment the three LEDs on the right
are off.
This display is off in the fixed command control
mode.
Display panel 1
Display
panel 2
Basic display LEDs
The LEDs go on when respective
function is operating.
Detailed descriptions follow.
PROFILE
(4)
Rising temperature lamp
(5)SOAK
(6)
Falling temperature lamp
(1)
Falling temperature lamp
(2)SOAK
(3)
Rising temperature lamp
Current
segment
Next
segment
To Next Page
Loading...
