Azbil dcp551 mark II - Setting pattern link items

8-18
■ Setting pattern link items
(1) In the set value display state, move to the pattern link item to be set for the
segment on the programming map.
(A pattern link item is a program setting and is the same for each segment.)
(2) Press the ENTER key to make display panel 2 flash (registration of first
setting).
(3) Use the , , , and keys to make the first setting – setting the pattern
link value.
Setting range: 0 to 99
0: no pattern link
1 to 99 : program number at pattern link destination
(4) Press the ENTER key to stop the flashing on display panel 2.
(Pressing the FUNC and CLR keys causes display panel 2 to return to unset
state “0 ”and the flashing stops.)
● Display
•A pattern link item is a program setting and is the same for each segment.
• When setup data C60 is set to 1, a pattern link item on the programming map is
skipped and not displayed.
NOTE
A pattern link item setting does not use subfunctions.
PROG SEG
PROFILE
Program
number
Segment
number
Pattern trend
PATTERN LINK
Set program value
at link destination
Chapter 8. PROGRAM SETUP