Item Specifications
Mode
Control section
Program run mode READY
RUN
HOLD
FAST
END
READY FAST
Proportional band (P)
Output section
PID control 0.0 to 1000.0% (0.0: On-off control)
Integral time (I)
0 to 3600s (0: PD control)
Derivative time (D)
0 to 1200s (0: PI control)
Manipulated variable
limit
Low-limit : -5.0% to high-limit
High-limit : Low-limit to +105.0%
Manual reset
0.0 to 100.0%
Programmer function
Auxiliary output
Auto tuning
Automatic setting of PID value by limit cycle method
Manipulated variable change
0.1 to 110.0%/0.1s
On-off control differential
0 to 1000U
Scaling
Possible
Scaling
Possible
Selection
Manipulated variable output is selectable to SP output
Type
PV, SP, deviation, MV, PV1, PV2
Output resolution
1/10000
PID groups selection
Segment specified, automatic zone selectable during
program run
No. of PID groups
16 groups for program operation (9 segment specific
and 7 automatic zone selecting)
Fixed command control
mode
READY : Preparation state (control stop)
RUN : Run state
AUTO : Automatic run state
MANUAL : Manual run state (output is operatable to console)
AUTO
: Automatic run state
MANUAL
:
Manual run state (Enables manual output from system console.)
Normal reverse operation selection
Selection is settable
Current output (5G)
Auxiliary output CH1, CH2
:
Preparation state (control stop, select of program number is possible.)
: Advancing run state
: Hold run state
: Fast feed run state
: End point run state
: Preparation and the fast feed state
: 4 to 20mAdc
: Lower than 600Ω (under operating conditions)
: Lower than 0.1% FS (under the standard conditions)
: 1/10000
: 21.6mAdc
: 2.4mAdc
: 0.1s
: Lower than 25V
Output current
Allowable load resistance
Output accuracy
Output resolution
Max. output current
Min. output current
Output update cycle
Open time terminal voltage
Chapter 12. SPECIFICATIONS
To Next Page
Loading...
