Azbil dcp551 mark II - Page 206

6
Event Meaning Setting Operation Auxiliary settings
type category category
24 to 63 Event off ----- ----- Auxiliary 1 : None Auxiliary 2 : None
64 Normal PV1 upper limit operation Measuring instrument PV Auxiliary 1 : Hysteresis Auxiliary 2 : Operating point
65 Normal PV1 lower limit operation
66 Normal PV2 upper limit operation
67 Normal PV2 lower limit operation
68 PV upper limit
69 PV lower limit
70 Deviation upper limit
71 Deviation lower limit
72
Deviation upper limit with standby
73 Deviation lower limit with standby
74 Absolute value deviation upper limit
75 Absolute value deviation lower limit
76 Absolute value deviation upper limit with standby
77 Absolute value deviation lower limit with standby
78 PV deviation rate upper limit Measuring instrument PV Auxiliary 1 : Sampling cycle Auxiliary 2 : Operating point
79 PV deviation rate lower limit
80 SP upper limit Measuring instrument PV Auxiliary 1 : Hysteresis Auxiliary 2 : Operating point
81 SP lower limit
82 MV upper limit
83 MV lower limit
84 SOAK absolute value deviation upper limit
85 SOAK absolute value deviation lower limit
86 SOAK absolute value deviation upper limit with standby
87 SOAK absolute value deviation lower limit with standby
88 Program No. binary code Measuring instrument Code Auxiliary 1 : No. of output Auxiliary 2 : None
89 Segment No. binary code
90 Program No. BCD code
91 Segment No. BCD code
92 Specified segment Measuring instrument Mode Auxiliary 1 : Segment specification Auxiliary 2 : None
93 RAMP-E monitoring time Measuring instrument Time Auxiliary 1 : Operating point Auxiliary 2 : None
94 Segment time Measuring instrument Time Auxiliary 1 : On-time Auxiliary 2 : OFF-time
95 Program time
96
PV1-PV2 differential upper limit Measuring instrument PV Auxiliary 1 : None Auxiliary 2 : Operating point
during CH switching
97
PV1-PV2 differential lower limit
during CH switching
98
PV1-PV2 differential upper limit Measuring instrument PV Auxiliary 1 : Hysteresis Auxiliary 2 : Operating point
99 PV1-PV2 differential lower limit
100 to 127 Event off ----- ----- Auxiliary 1 : None Auxiliary 2 : None
128 RUN, HOLD, END, FAST Measuring instrument Mode Auxiliary 1 : None Auxiliary 2 : None
129 HOLD
130 READY, READY FAST
131 END
132 G.SOAK wait
133 MANUAL
134 AT executing
135 FAST, READY FAST
136 Console setting operation
137 RUN
DCP551 Parameter Work Sheet