Azbil dcp551 mark II - Page 66

5-14
• Program/segment number event
A program or a binary coded segment number is set in an event type and the
number of output points (1 to 7) is set in auxiliary setting 1. Or a program or a
BCD code of the segment number is set in an event type and the number of
output points (1 to 8) is set in auxiliary setting 1.
A selection, a program designed for a specific operation or a coded segment
number is output. A low-order bit code corresponding to the set number of
output points is output.
• An event on delay can be combined with the code event.
Note, however, that when there are several channel code events, the delay has
to be entered for each channel.
Decimal
1
Binary code output
(0: Off output 1: On output)
0 0 0 0 0 0 1
2
0 0 0 0 0 1 0
3
0 0 0 0 0 1 1
4
0 0 0 0 1 0 0
5
0 0 0 0 1 0 1
6
0 0 0 0 1 1 0
7
0 0 0 0 1 1 1
8
0 0 0 1 0 0 0
9
0 0 0 1 0 0 1
10
0 0 0 1 0 1 0
11
0 0 0 1 0 1 1
12
0 0 0 1 1 0 0
13
0 0 0 1 1 0 1
14
0 0 0 1 1 1 0
15
0 0 0 1 1 1 1
16
0 0 1 0 0 0 0
17
0 0 1 0 0 0 1
•
•
•
Decimal
1
BCD code output
(0: Off output 1: On output)
0 0 0 0 0 0 0 1
2
0 0 0 0 0 0 1 0
3
0 0 0 0 0 0 1 1
4
0 0 0 0 0 1 0 0
5
0 0 0 0 0 1 0 1
6
0 0 0 0 0 1 1 0
7
0 0 0 0 0 1 1 1
8
0 0 0 0 1 0 0 0
9
0 0 0 0 1 0 0 1
10
0 0 0 1 0 0 0 0
11
0 0 0 1 0 0 0 1
12
0 0 0 1 0 0 1 0
•
•
•
20
0 0 1 0 0 0 0 0
30
0 0 1 1 0 0 0 0
40
0 1 0 0 0 0 0 0
50
0 1 0 1 0 0 0 0
•
•
•
Decimal binary code comparison table
Decimal BCD code comparison table
Chapter 5. FUNCTIONS