To Next Page

To Previous Page

2. Safety

2.2 Important safety instructions

To prevent the risk of electrical shock

• This projector should be operated from an A C power source. Ensure that the m ains voltage and capacity matches the projector

electrical ratings. If you are unable to install the AC requirements, contact your electrician. Do not defeat the purpose of the

grounding.

• Installation according to the local electrical code and regulations by qualiﬁed technical personnel only.

• A readily accessible disconnect device mu st be incorporated externally to the equipment for removal of the power to the pro-

jector cord.

• Warning: High leakage current. Earth connection essential before connecting supply.

• Do not allow anything to rest on the power cord. Do not locate this projector where persons will walk on the cord.

• Do no t op erate the projector w ith a damaged cord or if the projector has been dropped or damaged - until it has been examined

and approved for operation by a qualiﬁed service technician.

• Position the cord so that it will not be tripped over, pulled, or c ontact hot su rfaces.

• If an extension cord is necessary, a cord with a current rating at least equal to that of the projector should be used. A cord rated

for less amperage than the projec tor may overheat.

• Never push objec ts of any kind into this pr ojector through cabinet s lots as they may touch dangerous voltage po ints or short

circuit parts that could result in a risk of ﬁre or electrical shoc k.

• Do not expose this projector to rain or moisture.

• Do not immerse or expose this projector in w ater or other liquids.

• Do not spill liquid of any kind on this projector.

• Should any liquid or solid object fall into the cabinet, unp lug the set and hav e it checked by qualiﬁed service personnel before

resuming op erations.

• Do not disassemble this projector, always take it to a t rained service person when service or repair work is required.

• Do not use an accessory attachm ent which is not r ecom mended by the m anufacturer.

• Lightning - For added protection for this video product during a lightning storm, or when it is left unattended and unused for

long periods of time, r emov e all power from the projector. This will pr event damage to the projector due to lightning and AC

power-line surges.

601–0307–00 F50 25/02/2016

Barco F50 User Manual

Other manuals for Barco F50