7. Change projector settings
7.4 Review and change network settings
General
The projector uses Dynamic Host Configuration Protocol (DHCP) to en able better identification and control of the projector when
connected to the Loc al Area Network (LAN).
DHCP is enabled by default. It can be disabled from Main Menu — Settings — Network — Change LAN s ettings
When DHCP is enabled, current network settings are automatically displayed at Main Menu — Settings — Network.
When DHCP is disabled, users can set a fixed I P address for the p rojector at Main Menu — Settings — Network — Change LAN
settings.
601–0307–00 F50 25/02/2016
67
To Next Page
Loading...
Need help?
General
