8. Set up the picture
8. SET UP THE PICTURE
About
This chapter describes how to set up and adjust t he picture display in order to get the best possible image on screen.
For best results, picture adjustments should be carried out whenever the source, signal type and/or format is changed. General set-
tings out of the box are standardized to meet accepted indus try standard signal levels. Signal levels deviating from these standards
will need proper calibration before the output ma tches the desired result.
Wherever pos sible, w e recommend you use c ustomize d test images during picture adjustments.
In g eneral, the following order is recommended when adjusting the pic ture display:
1. Contrast
2. G amm a
3. Brightness
4. Saturation
Overview
• Select the image orientation
• Use test image s
• Set up Picture-by-Picture
• Apply a display profile
• Adjus t lamp power
• U se gamma curves
• Adjus t brightness, saturation and contrast
• Choose an as pect ratio
601–0307–00 F50 25/02/2016
71
To Next Page
