2. Safety
On servicing
• Do not attempt to service this pr oduct yourself, as o pening or removing covers may expose you to dangerous voltage potentials
and risk of electric s hock.
• Refer all servicing to qualified s ervice personnel.
• Attempts to alter the factory-set internal c ontrols or to change o ther control settings not specially discussed in this m anual c an
lead to permanent dam age to the pr ojector and cancellation of the warranty.
• Remove all po wer from the projector and refer servicing to qualified service technicians under the following conditions:
- When the power cord or plug is da maged or frayed.
- If liquid has bee n spilled into the equipment.
- If the product has b een expo sed to rain or water.
- If the product does not operate norm ally wh en the operating instructions are followed. Adjus t only t hose controls that are
covered by the operating instructions since im proper adjustment of the other c ontrols may result in dam age and will often
require extensive work by a qualified technician to restore the product to normal operation.
- If the product has been dropped or the cabinet has been damaged.
- If the product exhibits a distinct change in per formance, indicating a need for service.
• Replacement pa rts: W hen replacement pa rts ar e r equired, be sure the service technician has us ed original Barco replac ement
parts or authorized replacement parts which have the same characteristics as the Barco original part. Unauthorized substitu-
tions may result in degraded performance and reliability, fire, electric shock or other h azards. Unauthorized substitutions may
void warra nty.
• Safety check: Upon completion of any service or repairs to this projector, ask the service technician to perform safety checks
to determine that the pr oduct is in proper operating condition.
• Possible explosion hazard: Always keep in mind the caution below:
To prevent battery explosion
• Danger of explosion if battery is incorrectly installed.
• Replace only with the same or equivalent type recommended by the manufacturer.
• For disposal of used batteries, always consult federal, state, local a nd provincial hazardous waste disposal rules and regulations
to ensure proper disposal.
12
601–0307–00 F50 25/02/2016
To Next Page
Loading...
Need help?
General
