7. Advanced
Image 7-101
4. Use the cursor key ↑ and ↓ to select the desired geometry file and press ENTER to select.
A message will be displayed.
Image 7-102
5. Press ENTER to confirm.
The selected fi le is deleted and removed from the list.
6. Press BACK to return to the Geom etry E dit menu.
7.7 Lamps
Overview
• Lamp info
• Lamp runtime warning
• Lamp Power Mode
• Constant Light Output (CLO)
7.7.1 Lamp info
What can be done?
All information about the lamp is stored inside the lamp house (EEPROM) and can be displayed via the projector’s OSD. This is
read only information and can not be changed.
Following Lamp Information can be consulted :
Values Description
Power :
Minimum minimum power
Maximum maximum power
Current
current power
Lumens
light output (arbitrary unit)
Runtime :
Current
Total time the lamp is used in this projector
R59770286 NW-12 07/09/2009 109
To Next Page
Loading...
