Barco NW-12 - Lens Installation

4. Installation
Projector Projector
Screen
Vertical Shift in Nominal Position
Screen
Screen
Vertical Shift : +100% Vertical Shift : -25%
Projector
Image 4-5
Example of a vertical shift of +100% and -25%
4.2.4 Lens installation
Necessary tools
Hexagonal key 4 mm (hexagonal) - delivered with the projector
Necessary parts
• Lens
• Lens interface plate (pre-mounted on the lens holder)
• 4x M5x12 screws (delivered with the projector and with the lens)
How to install the lens ?
1. Remove the lens interface plate from the lens holder if it is still mounted to it
2. Fix the lens interface plate to the lens using the delivered screws (4)
Note: Install the lens and the lens interface plate with their s creening UP or TOP or iented in the same direction
Caution: Mind the orientation of the lens interface plate in relation to the lens.
UP
Image 4-6
Assembling the lens, screening UP to the top side
R59770286 NW-12 07/09/2009 17