7. Advanced
Image 7-35
8. Press ENTER
A dialog box is displayed
9. Adjust the red white level (gain) on a minimal value
Image 7-36
10.Adjust the blue white level (gain) to a minimal value
Note: this m inimal value is not necessary , provided that the 2 other colors are not influencing too much the color to be adjus ted,
in fact the aim is to minimize the effect of the two other colors since there is a risk of reaching too s oon the transition
(bright spots) due to the contribution of these two other colors signals.
11.Adjust the Green white level (gain) until bright spots appear on the white part of the image
12.Adjust the Blue white level (gain) until bright spots appear on the white part of the image
13.Adjust the Red white level (gain) until bright spots appear on the white part of the image
The projected image should now be noisy neutral grey.
If one uses a checkerboard pattern, the bright spot
s should appear in the white blocks.
The input balance settings are stored in the image file, each source has its own input balance.
7.5 Image files
Overview
• Introduction to Image files
• Load file
•Forcedfile load
• Auto Image
•Editfile
• Save as (create a custom file)
• Rename file
• Copy
• Delete
R59770286 NW-12 07/09/2009
73
To Next Page
Loading...
