7. Advanced
Image 7-40
Note: Inputs that ar e not hardware compatible with this layer are greyed out.
Note: if a file is already forced for that input it will be shown on the right.
9. Press ENTER
The Loa d dialog box is displayed
10.Use ↑ or ↓ to select the desired fi le (for example /Standard/SXGA+@60.xml)
11. Pres s ENTER
The file is selected and will be loaded in the future.
To delete the forced file, go to the desired input and press ENTER.
7.5.4 Auto Image
What can be done ?
Auto Image creates the best suited image file for the connected source.
It calculates/measures several source parameters :
• Total pixels per line
•Startpixel
•Phase
• Contrast/Brightness levels
Auto Image only works for data images.
The measure of the total number of pixels per line can be done through 2 methods
• Limited scan: a windowing system is used to allow fast tracking.
The operation takes about 20 seconds (depending on file)
• Full scan: tracking is done over the full range.
The operation takes about 1.5 minutes (depending on file)
HowtolaunchAutoImage?
1. Press MENU to activate the Tool bar
76
R59770286 NW-12 07/09/2009
To Next Page
Loading...
