7. Advanced
100
20
40
60
80
200 400 600 800 1000
Relative Light Output (%)
Runtime (hrs)
Constant Light Output
working area
Image 7-109
CLO can not be enabled (ON) if the lamp is working in Economic mode.
How to set the CLO On or Off ?
1. Press MENU to activate the Tool bar
2. Press → to select the Lamp item
3. Press ↓ to Pull down the Lamp menu
4. Use ↑ or ↓ to select CLO
5. Press → to pull down the menu
6. Use ↑ or ↓ to select Mode
7. Press → to pull down the menu
8. Use ↑ or ↓ to select ON or OFF
Image 7-110
9. Press ENTER
A bullet shows the active setting
7.7.4.2 CLO Target
What must be done?
The light output target for the CLO is set in this menu. This value will be forced on the projector provided the CLO has been set ON.
Two targets can be set : one for the standard mode and one for the Infitec
TM
mode.
How to set the CLO target ?
1. Press MENU to activate the Tool bar
2. Press → to select the Lamp item
3. Press ↓ to Pull down the Lamp menu
R59770286 NW-12 07/09/2009
113
To Next Page
Loading...
