7. Advanced
Values Description
Warning Time set at which a warning is generated. Using the lamp longer than the maximum run time
may damage the projector
Number of strikes
Total times the lamp is started up
Hardware :
Serial number Unique serial number of the lamp
Article number
Article number of the lamp
EEPROM version version of the EEPROM used in the lamp housing
Table 7 - 4
Lamp Information
Howtodisplaythelampinfo?
1. Press MENU to activate the Tool bar
2. Press → to select the Lamp item
3. Press ↓ to Pull down the Lamp menu
4. Use ↑ or ↓ to select Info...
Image 7-103
5. Press ENTER
A text box is displayed
Image 7-104
7.7.2 Lamp runtime warning
What can be done ?
When the lamp has reached a predetermined runtime , a warning message will be displayed on the screen. The lamp runtime
warning can be set in a range from 30 to 200 hours. The runtime warning is displayed by default at 30 hours before end of lamp
lifetime. This warning message can be removed by hitting Back on the RCU.
110
R59770286 NW-12 07/09/2009
To Next Page
Loading...
