Barco NW-12 - Connections; Power Connection

4. Installation
4.5 Connections
Overview
• Power connection
• The front panel
• Connecting an RGB signal
• Connecting a component video signal
• Connecting a DVI signal
• Connecting a Composite video signal
• Connecting an S-Video signal
• Connecting a Computer
• Connecting a source to the desktop input
• Communications
• Multichannel Installations
4.5.1 Power connection
Electrical ratings
Projector type
Voltage (AC) Current / Power
Frequency
NH-12 230V single phase 12 Amps 50-60 Hz
Galaxy NH-12
230V single phase 12 Amps 50-60 Hz
iD LH-12 230V single phase 12 Amps 50-60 Hz
NW-12 220–240V single phase 12 Amps 50-60 Hz
Galaxy NW-12
220–240V single phase 12 Amps 50-60 Hz
Galaxy NW-7
220–240V single phase 12 Amps 50-60 Hz
Power connection
1. Use the supplied power cord to connect the projector to the power outlet.
2. Plug the female power connector into the male connector at the front of the projector, secure the connection with the locking
spring.
Image 4-12
Power connection
22 R59770286 NW-12 07/09/2009