Barco NW-12 - Menu Bar Position; Status Bar Position

7. Advanced
Image 7-122
A bullet shows the active setting
7.9.3 Menu bar position
What can be done ?
The menu tool bar can be centered vertically , the range being from top of the screen to the middle of the screen. This can be useful
in applications where the top image content is not displayed (soft edge region).
How to center the menu ?
1. Press MENU to activate the tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Menu bar position menu
5. Press ENTER
Image 7-123
6. Use ↑ or ↓ to position the Menu bar
7.9.4 Status bar position
What can be done ?
The status bar (wizard menu) can be centered vertically , the range being from bottom of the screen to the middle of the screen.
This can be useful in applications where the bottom image content is not displayed ( soft edge region).
How to center the menu ?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Status bar position
120
R59770286 NW-12 07/09/2009