Barco NW-12 - Page 123

7. Advanced
Galaxy NW-7 has an extra step procedure which is described below !
If Full screen synchronous representation is disabled, smoothly moving images can show chopped motion!
How to enable/disable the full-screen synchronous representation in (Galaxy) NW-12/NH-12,
NW-12, iD LH12, iCon NH-12 ?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Full-screen sy nchronous representation
5. Press → to open the menu
6. Use ↑ or ↓ to select ON to enable or OFF to disable
7. Press ENTER
Image 7-121
A bullet shows the active setting
How to enable/disable the full-screen synchronous representation in Galaxy NW-7?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Full-screen sy nchronous representation
5. Press → to open the menu
6. Use ↑ or ↓ to select Mode
7. Press → to open the menu
8. Use ↑ or ↓ to select ON to enable or OFF to disable
9. Press ENTER
R59770286 NW-12 07/09/2009
119