Barco NW-12 - Introduction to Image Files; Load File

7. Advanced
7.5.1 Introduction to Image files
Image files
An image file contains the main characteristics of a source (number of active lines,...). The projector’s memory contains a list of files
corresponding to the most common sources : standard files.
When a new source corresponds to one of these files, a custom file is created. The custom file is automatically saved if a setting is
altered (contrast, ...). The Sav e as... function allows to create and save a custom file.
The active filecanalwaysbeeditedinordertofit exactly the source specifications.
AutoImage creates automatically the best suited image file (custom file) for a new source. AutoImage is used
when :
- a new source is detected: AutoImage creates a new custom file which can always be edited if necessary.
- the AutoImage is launched via the button on the RCU, the projector’s OSD or from the desktop’s OSD
File notation
The notation of the image file happens as follows :
/Standard/SXGA+@60.xml
Type of file : standard or custom
Resolution
Vertical freq
file extension = xml
Image 7-37
7.5.2 Load file
When to load a file ?
In some cases the user wants a particular file to be used for the display of a particular source. In this case the user should load the
desired file from the image files menu. The load file option will allow the user to choose between several files corresponding more
or less to the active source specifications.
In normal operation the file selection (load) will be done automatically by Auto Image.
Howtoloadafile ?
1. Press MENU to activate the Tool bar
2. Press → to select the Im age files item
3. Press ↓ to Pull down the Im age files menu
4. Use ↑ or ↓ to select Load
Image 7-38
74 R59770286 NW-12 07/09/2009