Barco NW-12 - Formatter Patterns; Lfr

7. Advanced
7.10.3 Formatter patterns
Overview
Image 7-188
Horizontal ramp
Image 7-189
Vertical ramp
How to select a formatter pattern ?
1. Press MENU to activate the Tool bar
2. Press → to select the Installation menu
3. Press ↓ to Pull down the menu
4. Use ↑ or ↓ to select Formatter Patterns
Image 7-190
5. Press → to Pull down the menu
6. Use ↑ or ↓ to select the desired pattern
7. Press ENTER
The active selection is shown with a white bullet
7.10.4 LFR
How to use the LFR ?
1. The LFR is by default ON. Leave it in the default position.
156
R59770286 NW-12 07/09/2009