Barco NW-12 - The Front Panel

4. Installation
OPEN
LOCKED
Image 4-13
Power plug spring system
4.5.2 The front panel
View
The front panel of the projector can be divided in 2 major parts :
1. Signal Input/Output section
2. System input/output section
2
DESKTOP INPUT
DESKTOP INPUT
DVI
DVI
COMPUTER
COMPUTER
RS 232 C
RS 232 C
DVI
DVI
R.C.
R.C.
DESKTOP INPUT
DVI COMPUTER
RS 232 C
DVI R.C.
1
R / PR
R / PR
G / Y
G / Y
B / PB
B / PB
Hs / Cs
Hs / Cs
Vs
Vs
VIDEO
VIDEO
S-VIDEO
S-VIDEO
R / PR
G / Y
B / PB
Hs / Cs
Vs
VIDEO S-VIDEO
2
Image 4-14
Front panel connections
The signal input/output section
The input/output section has a modular architecture i.e. it is composed of several (5) slots which can be equipped with different input
modules :
The different available inputs that can be installed :
• RGBHV & Video analog input
• HDCP DVI & Computer (D15) VGA input
• SDI/HDSDI (option)
• DVI/HDMI (HDCP) (option)
The different available outputs :
• DVI output & RS232 IN
The projector is by default equipped as follows:
• Layer 1: empty (can be fitted with any input board)
• Layer 2: empty (can be fitted with any input board)
• Layer 3: RGB & Video input board (fixed)
• Layer 4: DVI & D15 input board (fixed)
• Layer 5: DVI output and RS232 board (fixed)
R59770286 NW-12 07/09/2009
23