7. Advanced
7.11.4.2 Warning messages
What can be done?
It is possible to block some Warning messages during projector runtime. The table below gives an overview of those messages that
can be suppressed during runtime.
Warning message
Sim 5W Galaxy NH-12
Galaxy NW-12
Galaxy NW-7
Description
NO SIGNAL
xx
In case no incoming Sync is detected
Lamp error icon
x
In case of an actual lamp or LPS problem
Lamp runtime warning
xx
Max lamp runtime almost reached
Lamp runtime exceeded
xx
Max lamp runtime exceeded
Desktop resolution not valid
x
Desktop input signal resolution is out of
specification.
Wait box
xx
An hourglass icon that is displayed during
processing
For safety reasons, the warning messages Lamp runtime warning and Lamp runtime exceeded will always
pop up during start-up of the projector. They can only be suppressed during projector runtime.
How to enable/disable Warning Messages?
1. Press MENU to activate the Tool bar
2. Press → to select the Service item
3. Press ↓ to Pull down the Service menu
4. Use ↑ or ↓ to select Opera tion options
5. Press → to pull down the Operation Options menu
6. Use ↑ of ↓ to select Warning M essa ges
7. Press → to pull down the War ning Messages menu
8. Use ↑ or ↓ to select On or Off
9. Press ENTER to confirm
Image 7-196
A white bullet shows the active setting
160
R59770286 NW-12 07/09/2009
To Next Page
Loading...
