Barco NW-12 - Display Setup; Textbox; Full Screen Synchronous Representation

7. Advanced
7.9 Display setup
Overview
• Textbox
• Full screen synchronous representation
• Menu bar position
• Status bar position
• Slider box position
• Dynacolor
• Soft edge
• AutoImage Setup
7.9.1 Textbox
What can be done ?
The Text box function allows to choose whether the different text boxes are displayed or not.
How to enable/disable the Textbox ?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Textbox
5. Press → to pull down the menu
6. Use ↓ or ↑ to enable (ON) or disable (OFF) the textbox
Image 7-120
7. Press ENTER
A white bullet shows the active setting
7.9.2 Full screen synchronous representation
What can be done?
In full screen, the display can be driven in synchronous or asynchronous mode. In the synchronous mode, the display will be
refreshed at the same vertical frequency as the displayed source.
In the asynchronous mode, the display will be refre
shed at a fixed vertical frequency depending on the OSD setting, instead of the
vertical frequency of the displayed source.
The maximal vertical refresh rate of the display is 120Hz.
Fixed vertical refresh rate during asynchronous mode:
50 Hz or 60 Hz if the projector is Galaxy NW-7 and 60 Hz if the projector are (Galaxy) NW-12/NH-12, NW-12, iD
LH12, iCon NH-12.
118 R59770286 NW-12 07/09/2009