5. Setup
Image 5-21
5.9 Setup of linked projectors in a multichannel system
What can be done ?
The user interface of the projector allows to link up to 10 (slave) projectors to a single Master projector. The linking itself is done
through an Ethernet connection (see Communications). The ’software’ linking itself is done in the Linked projectors menu of the
Installation menu.
A single dialog box allows to declare (in the Master projector ! ) the 10 slave projectors by their IP address or host name and to set
the following parameters to be controlled by the Master i.e.
it allows to add the projector to the different control loops by a simple
check :
• CLO: adding the projector to this control loop will allow the brightness (light output) of the projector to be controlled by the master
• Dynacolor : adding the projector to this control loop will allow the displayed primary and secondary colors of the projector to be
controlled by the Master
This information has to be declared in the Master projector since this projector must know all the projectors it has to talk to.
The linked p rojector menu in the Slave projectors will remain greyed out.
How to start up the linked projector menu ?
1. Press MENU to activate the Tool bar
2. Press → to select the Installation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Linked projectors...
Image 5-22
5. Press ENTER
R59770286 NW-12 07/09/2009
49
To Next Page
Loading...
