Barco NW-12 - 9. Trouble Shooting; 9.1 Error codes

7. Advanced
Image 7-193
5. Press ENTER
A dialog box is displayed
Image 7-194
6. Fill in the key by using the digit and the arrow keys
7.11.3 Calibration of CLO sensor
How to calibrate the CLO sensor ?
1. See the service manual for the complete procedure
7.11.4 Operation options
Overview
• AutoImage
• Warning messages
7.11.4.1 AutoImage
What can be done ?
AutoImage can be disabled. In case of a new (unknow) source, no automatic file selection will be done. Instead, a more or less
suited file will be selected, resulting in a misaligned image. Image settings must be done manually (edit image file).
How to enable/disable AutoImage ?
1. Press MENU to activate the Tool bar
2. Press → to select the Service item
3. Press ↓ to Pull down the menu
4. Use ↑ or ↓ to select Opera tion options
5. Press → to pull down the menu
6. Press ↓ to select Autoimage
7. Press → to pull down the menu
8. Use ↑ or ↓ to select On/Off
9. Press ENTER
Image 7-195
A white bullet shows the active setting
R59770286 NW-12 07/09/2009
159