5. Setup
Image 5-24
How to set a projector as Slave ?
1. In the linked projector menu of the master projector, Select the Hostx check box and press ENTER
The ip address edit box is enabled
2. Fill in the IP address or Host name of the projector to be declared as slave i.e. to be controlled by the Master
For example IP address 150.158.193.110
3. Select and press ENTER for the desire
d parameters to be controlled by the master i.e. CLO and/or Dynacolor and/or Stereo
It is advised to declare the projector by a Host name (unique name in the network).
The Dynacolor options are used to perform the Dynacolor linking, see Dynacolor adjustment in the Display
Setup menu.
R59770286 NW-12 07/09/2009 51
To Next Page
Loading...
