Components
Operator Manual for the Baxter ExactaMix 2400 Compounder
Page 6 53007410 Rev. C
DAILY USE COMPONENTS
• The valve set is a sterile, multiple-port valve with an outlet tube attached. The valve
body fits over the valve actuators on the compounder, protecting them from damage.
The outlet tube attaches to the destination bag. For ordering information, refer to Valve
Sets on Page 21.
• The inlet is a sterile tube with a spike or Luer end attached. The spike or Luer end
attaches to a source container, and the other end attaches to a port on the valve set.
The type of inlet that is used depends on the source container. For inlet types,
descriptions and ordering information, refer to Inlets on Page 18.
NOTE: The valve set and inlets are collectively known as the tube set.
• The destination bag is a sterile container that holds the fluid pumped from the source
containers. There are two main types of destination bags, which are available in
different sizes. For bag types, descriptions and ordering information, refer to Bags on
Page 19.
o The patient bag is used for delivering the finished solution to a patient. This bag
contains three ports for filling the bag, adding ingredients manually and
delivering the finished solution.
o The calibration bag is used for collecting any fluid that is not intended for a
patient. For example, this type of bag is used while calibrating and priming the
compounder. This bag contains only one port for filling the bag. The calibration
bag is available in North America only.
To Next Page
