Setting Up the Compounder
Operator Manual for the Baxter ExactaMix 2400 Compounder
Page 58 53007410 Rev. C
PRIMING AND VERIFYING
After the ingredients and inlets are attached, they must be primed and verified. This process
includes scanning the barcodes on each container and inlet, priming the inlets and verifying the
setup.
1. At the Setup Wizard screen, tap Prime and Verify.
Setup Wizard screen, priming and verifying
NOTE: To prime and verify without using the Setup Wizard, you can tap Compound >
Prime and Verify at the menu screen.
WARNING
It is important to use a barcode reader for
scanning labels during verification of
the setup.
2. If your facility:
• Uses barcode verification, continue with Verifying the Ingredient and Inlet Barcodes
on Page 59
• Does not use barcode verification, skip to Priming the Inlets and Verifying the Setup
on Page 62
To Next Page
Loading...
