baxter iLED 7 User Manual

Use
7990087_030_03 – 2080492 – 2023-01-19 41
10. Check the sterilizable handle for visible damage and a secure
fit on the lamp head.
11. Check the functionality of the surgical light with all control
modules in use.
Immediately take a faulty surgical light or control module out of
service, label it clearly as being defective and ensure it is not used
again. If there is damage or a fault, notify the technical customer
service.
Following any damage reported by a user, a functional check and
a visual inspection must be carried out by personnel trained to
perform these tasks by Baxter.
Weekly inspection At least once a week, a functional check and a visual inspection
must be carried out by personnel trained to perform these tasks
by Baxter.
If there is damage or a fault, notify Technical Customer Service.
Annual inspection The annual inspection must be performed by staff trained in this
work by Baxter.
The annual inspection includes a visual inspection and functional
inspection of the entire surgical light considering the following
inspection points.
– Check the components of the lamp head and the support arm
system for deformation
– Surface damage
– Check the support arm system and lamp head for paint
damage
– Check plastic parts for cracks, brittle spots and clouding
–Check welds for cracks
– The surgical light must be checked for completeness of all
plastic parts (such as covers and plugs)
– Check to ensure that device labels and information labels are
legible.
– Check the LEDs for functionality
– Check the joints for functionality
– Check the position of the end stops
– Check the effect of the spring and brake forces
– Check the safe mode function
5.3 Selection of functions
The functions of the surgical light are set with the following control
units:
– Control element
– SLC handle adapter (Sterile Light Control)
– Mobile Control 7,9
– Wall Control Panel
– Operating interface of an external control module
(OP integration systems using RS232 interface)
The commands of the individual control modules are executed in
the following sequence:
1. Control element
2. SLC handle adapter (Sterile Light Control)

baxter iLED 7 Specifications

General

Brand	baxter
Model	iLED 7
Category	Medical Equipment
Language	English