BAL2185_Grease_lubrication_pump_PICO_with_PICO-troniX1_-tronic_0519EN 10158410
...a product of
© BEKA 201 All !9 rights reserved
36
9.1.2 Changingand settingthe parameters
The setting ranges of the lubrication duration and of the cycle duration and the operational mode of the lubrication
duration can be changed at any time using the diagnosis software (with the current version available atBEKA-DiSys
www.beka-lube.de).
When the parameters are changed, the adhesive label in the inspection window of the protective housing has to be
exchangedaccordingly.
Theadhesive labelsfor theinspection windowcan beordered asneeded.
*revolutions
Within the setting range, the lubrication duration and the cycle duration can be changed at the grid switches in the
inspectionwindow ofthe protectivehousing (seefig. 36)using aflatscrewdriver
For this, remove the frame at the inspection window of the protective housing using a flat screwdriver, loosen the four
crosspoint screwsand removethe transparentinspection window.
After setting the parameters, the inspection window and the frame have to be closed properly
again;otherwise can intothe integratedcontrol unitand can it!water enter destroy
9.1.3 Operationalmode oftime-dependent cycleduration
Atthe operationalmode oftime dependentcycle duration,the cycleduration canbe setin hoursor minutes,depending on
theselected settingrange. The settingrange canbe changedusing thediagnosis software (with thecurrentBEKA-DiSys
versionavailable at )www.beka-lube.de .
Fig.37:
Time-dependent cycle duration
Time-dependent lubrication duration
Revolution-dependent lubrication duration
Lubrication duration
Time-dependent
cycle duration
Caution!
To Next Page
Loading...
Need help?
General
