© BEKA 201 !9 All rights reserved
BAL2185_Grease_lubrication_pump_PICO_with_PICO-troniX1_-tronic_0519EN 10158410
...a product of
5
2. Generalsafetyinstructions
Everybody who is in charge of the assembly, start-up, maintenance and operation of the device must read these
instructions carefully prior to assembly and start-up of the device at the machine! Furthermore, this manual must always
beavailable atthe siteof operation!
Basicinstructions forsetup, operationand maintenancecan befound below.
2.1 Safetyinstructions
Observe the general safety instructions within this key chapter as well as the special safety instructions in other chapters
ofthis operatingand assemblymanual.
Warning ofelectrical voltage.
Safety instructions, which might cause hazards to persons in case of non-observance, are marked with the
generaldanger symbol.
Thissymbol warnsof hotsurfaces.
Warning ofsuspended loads.
Warning of material damagedue to electrostatic discharge!Marks potential risks which mayresult in material
damage,if notavoided.
This heading is used if improper or general non-observance of the operating and assembly
manual,instructions, specifiedworkflow andthe likemight resultin damage.
Thisterm isused topoint outparticular details.
Instructions and notes directly attached to the device have to be strictly observed and kept in readable
condition!
2.2 Qualificationand trainingof staff
The staff in charge of operation, maintenance, inspection and assembly have to be qualified accordingly.
Competence,responsibilities andsupervision ofstaffmust beclearly definedby theoperator. Incase thestaff
does not have the necessary knowledge it has to be instructed and trained accordingly. The operator is
obligedto ensurethat thestafffully understandsthe contentsof thisuser information.
Caution!
Notice!
To Next Page
Loading...
Need help?
General
