6-4
6.3.1 Upgrading SMR
The SMR can be connected to the patient monitor through the SMR connector via a powered USB cable.
For details, see BeneVision N Series Patient Monitor Operator's Manual (P/N: 046-009995-00).
6.3.2 Upgrading Wireless Network Functions
Installation method: Refer to the corresponding section of this manual to install the wireless network functional
assembly in your patient monitor. Pleases install the assembly as shown in the following pictures.
How to use WiFi functions: See BeneVision N Series Patient Monitor Operator's Manual (P/N: 046-009995-00).
The wireless signal will be affected by inaccuracy installation location of the antenna.
6.3.3 Upgrading Recorder
Installation method: Refer to the corresponding section of this manual to install the recorder in your patient
monitor.
How to use the recorder: See BeneVision N Series Patient Monitor Operator's Manual (P/N: 046-009995-00).
To Next Page
Loading...