6-5
6.3.4 Upgrading iView System
Installation method: Refer to the corresponding section of this manual to install the related boards of the iView
upgrade package in your patient monitor.
How to use iView system functions: See BeneVision N Series Patient Monitor Operator's Manual (P/N: 046-009995-
00).
NOTE
During installation, use a blade to cut off the seals for the USB, DVI and network interface at the rear case
so that the interface can stretch out from the rear case.
6.3.5 Upgrading Independent Display Function
Installation method: Refer to the corresponding section of this manual to install the related boards of the
independent display upgrade package in your patient monitor.
How to use the independent display function: See BeneVision N Series Patient Monitor Operator's Manual (P/N:
046-009995-00).
During installation, use a blade to cut off the DVI seal at the rear case so that the interface can stretch out
from the rear case.
To Next Page
Loading...