3-10
FAST Y O Y N N Y Y
LEAP Y N Y N N N N
Note: Y means yes, N means No, O means optional.
The meaning of each configuration item is shown below:
AUT. Protocol (Phase2 Auth): When PEAP in the EAP Method is selected, the user can configure the following PEAP
inner methods: EAP-MSCHAPV2, EAP-GTC, EAP-TLS.
Identity: user identity, it is the user name in the AD, LDAP or local user management on the RADIUS server.
Anonymity: This item does not impact the authentication process. The function of this item is to hide the real name
(Identity).
Password: the password for the Identity.
CA Certificate: choose the CA Certificate from the imported certificates.
User Certificate: choose the User Certificate from the imported certificates.
PAC Certificate: When the EAP-FAST is selected, choose the PAC certificate from the imported certificates. If the
RADIUS server has support In-band PAC provisioning to provision the client with a PAC, then there is no need to
setup the PAC Certificate and password.
PAC password: When the EAP-FAST is selected, input the PAC password for the PAC Certificate. If the RADIUS server
has support In-band PAC provisioning to provision the client with a PAC, then there is no need to setup the PAC
Certificate and password.
3.8 Troubleshooting
Symptom Possible Cause Recommended Measure
The monitor cannot
connect to the AP
and an X is displayed
on the Wi-Fi signal
icon on the monitor.
The nearby AP is not turned on. Ensure that the AP is turned on and belong to the VLAN
where the monitor resides.
The monitor is not turned on in the
coverage area of the AP.
Walk to the coverage area of the AP and turn on the
monitor. Ensure that the signal strength indicated on the
monitor is larger than –65 dBm.
Ensure that the intra-frequency interference meets the
requirement.
The SSID, IP address acquisition
mode, and security mode are not
correctly configured on the
monitor.
Configure the information again by referring to this
manual.
The monitor fails. Check whether another monitor can get online. If yes,
restart the monitor and ensure that the configurations of
the two monitors are consistent. If the monitor still cannot
get online, return the monitor to Mindray for repair.
The monitor can
connect to the AP
but cannot connect
to the CMS.
The monitor is not admitted on the
CMS.
Admit the monitor on the CMS.
The monitor cannot obtain any IP
address and the IP addresses in the
IP address pool on the DHCP server
are used up.
Enable other network equipment to connect to the CMS
and check whether an IP address can be obtained.
If the problem cannot be solved, contact the IT
department.
To Next Page
Loading...