Attachment
144
2019-02 EN 5020079.00A.04
Message on the display Cause Repair
Buttonhole lever is not lowered. > Pull down the buttonhole lever as far as possible until it
clicks into place.
Wrong stitch plate is used. > Remove the stitch plate and insert the correct one.
Needle moves sideways. When the stitch plate is being changed, this picture appears
because the needle is likely to move.
The needle moves upwards. > Check that there are no other objects near the needle
plate.
> Touch the icon «Confirm» to raise the needle.
The hoop is not attached. > Attach the hoop.
The hoop is attached. > Remove the hoop.
The embroidery hoop is
calibrated.
> Touch the icon «Confirm».
To Next Page
Loading...
