37
Functions - Display
Personal memory permanent
⦁
select a stitch pattern and alter e.g. stitch length or
stitch width
⦁
touch the icon
►
the altered stitch pattern is saved
Basic setting of stitch pattern
⦁
touch the icon
►
any alterations of the selected stitch pattern are
reset to basic setting
Altering the pattern length 4
⦁
move the round knob in the Display using the
Touchscreen pen or the finger
►
pattern length (Standard = 100%) is infinitely
variable
⦁
extend or shorten in 1%-steps using «+»/«-» or
⦁
touch «+100%»-icon 2
►
pattern length is extended in 100%-steps
Maximum length is 1000%, shortest length 10%. Some
stitch patterns are limited and cannot be extended to
1000%.
Stitch Counter
⦁
when the desired length is obtained, press the
«Quick reverse»-button
►
the Display changes to «auto»
►
the selected stitch pattern is temporarily
programmed
Balance
To balance forward and reverse stitches.
Multi-Directional sewing
►
use the stitch width knob to rotate the stitch pattern
or combination in 0.5°-steps, the stitch length knob
for 1°-steps or the direct-selection buttons for
45°-steps into the desired direction
►
the sewing direction is shown in the left part of the
Display
►
the start is marked with a white dot and the end
with a red cross
►
the function only appears if the selected stitch can
be sewn in multiple directions
Permanent reverse sewing
The sewing computer sews the selected stitch pattern
in reverse.
Backstepping
►
the last 200 needle penetrations of a stitch pattern
are retraced, i.e. sewn backwards
Altering stitch density 3
Certain decorative stitches (e.g. No. 401) allow an alteration of
the stitch density. The set stitch pattern length will not be
affected.
⦁
touch «+»-icon
►
the stitch density is reduced in 0.05 mm-steps
►
the stitch distance is increased
⦁
touch «-»-icon
►
the stitch density is increased in 0.05 mm-steps
►
the stitch distance is decreased
►
touch «Back»-icon 1
►
the Function Overview appears again
1
2
34
To Next Page
