40
Functions - Display
Combination mode
1 Long stitch (without alphabets)
2 Font size in alphabets
3 Mirror Image left/right
4 Mirror Image up/down
5 Altering the pattern length
6 Balance
7 Multi-Directional sewing
8 Editing a combination at cursor position
9 Deleting
10 Editing the whole combination
11 Permanent reverse sewing
12 Backstepping
⦁
touch «Combi mode»-icon
⦁
select stitch pattern
⦁
touch «i»-icon
Long stitch (without alphabets)
the sewing computer sews every second stitch
(max. stitch length 12 mm)
applicable for practical and decorative stitches
Exception: alphabets
Font size in alphabets
⦁
select Alphabet
►
Font size is 9 mm
⦁
touch icon
►
small «A»
►
the font size is reduced
Mirror Image left/right
The sewing computer sews the stitch pattern mirrored,
left/right referring to the sewing direction.
Mirror Image up/down
The sewing computer sews the stitch pattern mirrored
up/down referring to the sewing direction.
Altering the pattern length
⦁
move the round knob in the Display using the touch
pen or the finger
►
pattern length (Standard = 100%) is infinitely
variable
⦁
extend or shorten in 1%-steps using «+»/«-»-icons
or
⦁
touch «+100%»-icon
►
the pattern length is extended in 100%-steps
Maximum length is 1000%, shortest length 10%. Some
stitch patterns are limited and cannot be extended to
1000%.
Balance
To balance forward and reverse stitches.
Multi-Directional Sewing
►
use the stitch width knob to rotate the stitch pattern
or combination in 0.5°-steps, the stitch length knob
for 1°-steps or the direct-selection buttons for
rotating in 45°-steps into the desired direction
►
the sewing direction is shown in the left part of the
Display
►
the start is marked with a white dot the end with a
red cross
►
the function only appears if the selected stitch can
be sewn in multiple directions
Editing combinations at cursor position
⦁
touch the icon
►
Display appears
Deleting
Deletes an individual stitch.
Editing the whole combination
⦁
touch the icon
►
Display appears
Permanent reverse sewing
The sewing computer sews the selected stitch pattern
in reverse.
Backstepping
►
the last 200 needle penetrations of a stitch pattern
are retraced, i.e. sewn backwards
Overview Functions Combi mode
1
4
7
2
3 5
6 8
9 10
11 12
To Next Page
