Bernina B 570 - Chapter 6 - Service Program; Starting the Test Program

BERNINA International AG Seestrasse 161 CH-8266 Steckborn Schweiz Seite 119 von 172
DRAFT – VERSION
Chapter 6 - Service Program
Starting the Test Program
Entering:
• Switch machine off ("0").
• Keep Quick revers-button pressed, and switch machine on.
• The machine moves the stepping motors to their home positions (brief motor noise).
• The machine is now in the Service Program basic position.
Exiting the test program:
• Switch machine off.
• Wait ca. 30 seconds. Then switch machine on again.
• The machine can now be used normally.
Basic position:
Sections 1 to 11 are selected in the basic position of the Service Program.
BERNINA 590, 570, 565, 540, 520, 500
1
Information
2 Screen, symbols
3 Location of sensors in the machine
4 Signals
5 Location of stepping motors in the
machine
6 Adjustments
7 Embroidery module (EMB)
11 Check-out tests