Bernina B 570 - Thread Cutter Clamping Mechanism (Solenoid)

BERNINA International AG Seestrasse 161 CH-8266 Steckborn Schweiz Seite 148 von 172
DRAFT – VERSION
6d Thread cutter clamping mechanism (solenoid)
Is used to carry out thread cutter solenoid test
Check:
• Select test 6d.
• Press icon to activate the solenoid. The colour of the
icon will change to light blue, ‘Running’ appears, and
the solenoid clicks.
• Press icon again to stop the solenoid. ‘Successful’
appears.
• To return to section 6, press .
Repair note:
• Check cables for deformation and/or
wear and tear.
• Replace complete clutch carriage (
see
4.3.11).
• Replace PCBA-Base (see 4.2.4).