BERNINA International AG Seestrasse 161 CH-8266 Steckborn Schweiz Seite 154 von 172
DRAFT – VERSION
6o Magnetic position encoder calibration
Is used to carry calibration of magnetic position encoder
Check:
• Use loop-lift gauge 734571.70.01 to adjust loop lift
position.
• Select test 6o.
• In loop lift position, press grey key reading
‘Calibration position reached’. With this, the
magnetic position encoder is calibrated.
• Now turn handwheel back clockwise until the loop-
lift gauge reaches stop again.
• A reference value of between 330 and 335 degree
should appear, and the dark grey bar at the bottom
should change to green.
• To return to section 6, press .
Repair note:
• Check loop lift (see 5.5.3
).
• Check functionality PCBA-Position (see test 4h).
• Replace PCBA-Position Hall (see4.2.5).
• Replace PCBA-Base (see 4.2.4)
6.7 Section 7 – Embroidery module (EMB)
7a Embroidery module connection
7b Embroidery hours
7c X-direction sensor
7d Y-direction sensor
7e X- and Y-directions of stepping motors
7f X-direction stepping motor
7g Y-direction stepping motor
7h Hoop reference point
7i Testing the test patterns
7j Customer view embroidery mode
7k Hoop recognition
7n Duration Run Embroidery Motors
A detailed description of the Service Program section 7 can be found in the Embroidery Module
Service- and Maintenance Manual.
To Next Page
