BERNINA International AG Seestrasse 161 CH-8266 Steckborn Schweiz Seite 155 von 172
DRAFT – VERSION
6.11 Section 11 – Check-out tests
Check:
This check-out is designed to give the technician the possibility to check the machine in its main categories,
before delivering it to the customer.
The first test (lower-thread sensor) as listed below will appear automatically on starting menu 11. On
successful completion of the test (lower-thread sensor) and confirming with , the next test follows
automatically.
Important!
If the test (lower-thread sensor) fails or is cancelled with , the program returns from check-out to Service
Program without saving the settings.
Check-out tests:
1 Lower-thread sensor, test 3c
2 Upper-thread sensor, test 4f
3 Balance, test 6b
4 Buttonhole calibration, test 6c
5 Lubrication and resetting the service stitches, test 1f
On completion of the last test and confirmation with , check-out program returns to Service Program main
menu.
To Next Page
