Binder KBF P 240 - Page 3

KBF P + KBF LQC + KBWF (E6) 11/2016 page 3/189
5.6
Principle of controller entries ............................................................................................................. 46
5.7 Performance during and after power failures .................................................................................... 46
5.8 Performance when opening the door ................................................................................................ 47
6. START UP ............................................................................................................ 47
6.1 Turning on the chamber .................................................................................................................... 47
6.2 Controller settings upon start up ....................................................................................................... 48
6.3 Turning on/off humidity control .......................................................................................................... 49
7. FUNCTION OF LIGHT MEASUREMENT, AND INTEGRATION: LIGHT
QUANTUM CONTROL – KBF LQC ..................................................................... 50
7.1 Display of the instantaneous and the integrated values .................................................................... 50
7.2 Measurement of illumination intensity and temporal integration ....................................................... 50
8. SET-POINT ENTRY IN “FIXED VALUE” OPERATING MODE ........................... 52
8.1 Set-point entry through the “Setpoints” menu ................................................................................... 53
8.2 Direct setpoint entry via Normal display ............................................................................................ 54
8.3 Automatic correction of the actual value when turning on or off the illumination .............................. 55
8.4 Light commutation and special controller functions via operation lines ............................................ 55
9. TIMER PROGRAM: STOPWATCH FUNCTION ................................................... 57
9.1 Starting a timer program ................................................................................................................... 57
9.1.1 Performance during program delay time ................................................................................. 58
9.2 Stopping a running timer program ..................................................................................................... 58
9.2.1 Pausing a running timer program ............................................................................................ 58
9.2.2 Cancelling a running timer program ........................................................................................ 59
9.3 Performance after the end of the program ........................................................................................ 59
10. TIME PROGRAMS ............................................................................................... 60
10.1 Starting an existing time program ..................................................................................................... 60
10.1.1 Performance during program delay time ................................................................................. 61
10.2 Stopping a running time program ...................................................................................................... 62
10.2.1 Pausing a running time program ............................................................................................. 62
10.2.2 Cancelling a running time program .......................................................................................... 62
10.3 Performance after the end of the program ........................................................................................ 62
10.4 Creating a new time program ............................................................................................................ 63
10.5 Program editor: program management ............................................................................................. 63
10.6 Section editor: Section management ................................................................................................ 65
10.6.1 Add a new section ................................................................................................................... 66
10.6.2 Copy and insert or replace a section ....................................................................................... 66
10.6.3 Deleting a section .................................................................................................................... 68
10.7 Value entry for a program section ..................................................................................................... 69
10.7.1 Section duration ....................................................................................................................... 70
10.7.2 Set-point ramp and set-point step ........................................................................................... 70
10.7.3 Light commutation and special controller functions via operation lines ................................... 72
10.7.4 Temperature setpoint .............................................................................................................. 73
10.7.5 Humidity setpoint ..................................................................................................................... 74
10.7.6 Fan speed setpoint .................................................................................................................. 74
10.7.7 UVA target dose value – KBF LQC ......................................................................................... 75
10.7.8 VIS target dose value – KBF LQC ........................................................................................... 75
10.7.9 Tolerance ranges ..................................................................................................................... 76
10.7.10 Repeating one or several sections within a time program ....................................................... 77
10.7.11 Saving the time program ......................................................................................................... 78
11. WEEK PROGRAMS ............................................................................................. 79
11.1 Starting an existing week program .................................................................................................... 79
11.2 Cancelling a running week program .................................................................................................. 80
11.3 Creating a new week program .......................................................................................................... 81
11.4 Program editor: program management ............................................................................................. 82