Bosch DB18C3100R2 - Configuring Automatic Alarm Recording

116 en | Default Configuration DiBos/DiBos Micro
F.01U.033.308 | V7 | 2009.09 Installation Guide Bosch Sicherheitssysteme GmbH
6.13.3 Configuring Automatic Alarm Recording
Options menu > Settings button
In this dialog box you can configure automatic alarm recording of a remote station alarm.
1Target directory:
Click and select the directory where the data
will be saved.
2 Start recording automatically Activate the check box to automatically save the data
for alarm input.
3 Monitor data size in target
directory
Activate the check box to monitor the size of the
saved data.
4 Warning for more than [MB] Enter the value for the data size in the target
directory. A warning is displayed if the value is
exceeded.
5 Monitor available memory on
target drive
Activate the check box to monitor available memory
on the target drive.
6 Error message for less than
[MB]
Enter the value for the available memory that the
actual value must fall below for an error message to
be displayed.
7 Delete old video Activate this check box when you want to delete data.
8 Older than [days]: Enter the number of days after which data should be
deleted.
Example: 3 means that all data older than 3 days is
automatically deleted.
9 OK The entries are saved.