94 en | Default Configuration DiBos/DiBos Micro
F.01U.033.308 | V7 | 2009.09 Installation Guide Bosch Sicherheitssysteme GmbH
6.7 Configuring Remote Stations
Remote stations menu
In this dialog box, you determine the remote stations for your own workstation (local
computer) so that you can connect to these remote stations later in the configuration
procedure.
1 Local settings Edit the following settings for your own workstation.
Modem/ISDN: Select the modem or ISDN card.
Note:
To configure a modem connection, an RAS-capable modem
must be connected and an RAS service installed.
Number of B channels Enter the number of B channels.
Accept incoming calls
(for standard users)
Incoming calls may be accepted by standard users.
Password... Enter the password that allows remote stations to be dialed
into.
System control... Under Windows XP, opens Network Connections in the
Control Panel.
Note:
Here you can configure your own IP address or make firewall
settings, for example.
Info If no RAS-capable modem is connected or no RAS service is
installed, a notes icon and a button with additional
information appears.
To Next Page
Loading...
Need help?
General
