DiBos/DiBos Micro Default Configuration | en 93
Bosch Sicherheitssysteme GmbH Installation Guide F.01U.033.308 | V7 | 2009.09
Configuring the e-mail server setup
Alarm processing menu > Configure E-mail... button
or
Error forwarding menu > E-mail server button
E-mails can be sent regardless of whether or not you log on to the SMTP server.
1 Transmitter name: Enter the name of the sender. The name appears as the
sender name for the e-mail recipient.
2 E-mail address: Enter the e-mail address of the sender.
3 SMTP server: Enter the name or the IP address of the SMTP servers (e-mail
server).
4 With log-on to SMTP
server
E-mails can only be sent when the sender is authorized to do
so. The SMTP server checks the sender's authorization in this
case.
5 User name: Enter the user name for logging on to the SMTP server.
6 Password: Enter the password for logging on to the SMTP server.
Password transmission is encrypted.
7 Save The entries are saved.
NOTICE!
– For information on how to add an e-mail recipient for alarm processing, see
Section 6.6 Configuring Alarm Processing
– For information on how to add an e-mail recipient for error forwarding, see
Section Adding a recipient/editing recipient data, page 110
To Next Page
Loading...
Need help?
General
