138 en | Connections DiBos/DiBos Micro
F.01U.033.308 | V7 | 2009.09 Installation Guide Bosch Sicherheitssysteme GmbH
Time lag: Select 0 (hours) and Daylight saving time
License: Enter serial number and activation code (please note these entries are case
sensitive) and confirm with OK.
– Click Save.
– Click Yes in the information window to start the Time Synchronization service.
Note:
A timer appears in the Windows XP task bar (at the bottom edge of the screen). This
confirms that the Time Synchronization program has started. The color of the clock
depends on the receiver status.
Yellow: Program starting (takes up to three minutes!)
Red: No synchronization or installation error
Green: Synchronization of system clock with receiver is OK.
6. Exit the NeoClock Time Server service as follows:
– Select Start -> Control Panel -> Administrative Tools -> Services.
–Double-click NeoClock Time Server and click Exit under Service Status (General
tab) to exit it.
– Deactivate the service by selecting Deactivated as the Start type.
–Confirm with OK and close the Services dialog box and the Control Panel.
7. Reboot the PC.
8. The NeoClock Time Server program must not be configured; instead, TARDIS should be
used. (Program used to synchronize video systems in a network; can be requested from
the video system manufacturer's video product service).
9. To position the clock, use the NeoClock XP operating manual (available on the CD as a
PDF file).
To Next Page
Loading...
Need help?
General
