56 en | Default Configuration DiBos/DiBos Micro
F.01U.033.308 | V7 | 2009.09 Installation Guide Bosch Sicherheitssysteme GmbH
1 Address: Enter the address (URL) of the camera and the command to
access the JPEG images.
The following syntax must be applied:
Bosch BVIP devices:
http://IP-Adresse/snap.jpg?JpegSize=S (for QCIF)
http://IP-Adresse/snap.jpg?JpegSize=M (for CIF)
http://IP-Adresse/snap.jpg?JpegSize=L (for 2CIF)
http://IP-Adresse/snap.jpg?JpegSize=XL (for 4CIF)
For multi-channel devices, the channel must be selected as
follows:
http://IP-Adresse/snap.jpg?JpegCam=2&JpegSize=XL (e.g.for
channel 2 and 4CIF)
Bosch MegaPixel IP camera:
http://IP-Adresse/image?res=full&x0=0&y0=0
&x1=100%&y1=100%&quality=12&doublescan=0
With HTTP, motion detection occurs via port [&mdn=Port
number].
tftp://IP-Adresse/
image?res=half&x0=0&y0=0&x1=1600&y1=1200&quality=15
With TFTP, the motion detection is retained in the image. It is
not necessary to configure a port.
Axis: http://IP-Adresse/jpg/image.jpg
Mobotix: http://IP-Adresse/record/current.jpg
Note:
More information can be found in the installation documents
of the relevant camera.
2 Display When you click the button, you can check whether the
entered URL and command are correct. If so, the camera
image appears.
3 Configure After the button is clicked, the configuration of the selected
JPEG device is displayed in a browser window.
4 Name: Enter the name of the camera.
5 Max. no. of images per
sec.:
Activate this check box and enter the number of images per
second to be displayed. This affects the network load when
viewing live images from the cameras.
Note:
The maximum number of displayed images depends on the
camera type and the parameters set for the camera (e.g.:
resolution, compression setting).
6 User name: Enter the camera user name and password needed for log-on
(e.g. Mobotix banking camera).
Password:
7 Motion camera If the IP camera is a motion detection camera, the video
system can be controlled when the sensor technology is
triggered. Activate the check box for this.
Port: Enter the port to which the camera sends the motion
information.
To Next Page
Loading...
